Changing the blank should trigger a fresh pre-operation check. Add a line that asks whether the material identity, supplier guidance, ventilation plan, shielding, protective equipment, and attended-operation conditions have been reviewed for the new test.
This matters even when the artwork stays the same. A familiar file does not make a different material familiar, and a previous sample does not replace the checks required for the next blank.
For an AntBelt G1 workflow, a written material-change line creates a clear stop point. If the material is unknown or the setup cannot be reviewed safely, the test should not proceed.
See /updates/ for additional AntBelt workflow notes; always follow official instructions and material guidance.
Visit the AntBelt G1 Kickstarter page to review current campaign details and follow the project: