Artwork that reads naturally on a flat screen can feel reversed or awkward when it wraps around an object. Before preparing a job, decide where the viewer starts reading and which side should face forward.
Make a paper wrap first
Print or sketch a low-cost paper version, wrap it around a representative object, and mark the intended front, start, and finish. Look at it from the angle a recipient would normally use. This reveals orientation problems without claiming that a particular material or setting will work.
AntBelt supports cylindrical engraving. Final accessory details, compatible object limits, and process settings should be confirmed from current project information and actual testing rather than inferred from a layout exercise.
Keep the seam out of important details
Move names, dates, and small marks away from the planned transition area where possible. Recheck the exported file, follow current operating guidance, and perform a suitable sample test before using the intended object.
Browse additional project notes in /updates/.
Review the current AntBelt G1 project information on Kickstarter: